Abstract
To improve the thermal efficiency of fossil running power plants increasing the live steam temperature is essential. In power plant construction, 9-12% chromium martensitic steels are widely used but if steam temperatures rise above 625 °C there is no way around nickel base alloys.
The scope of this study was to ascertain the weldability of cast nickel base alloy 625 with cast martensitic 9% chromium steel COST CB2, using electron beam welding (EBW). Similar (A625/A625) and dissimilar joint welding experiments on 50 mm thick plates were executed. Microstructure of welded joints was investigated and mechanical-technological tests were carried out.
Results show that work pieces were completely welded and the microstructure of the seam shows no problems except some δ-ferrite grains near the fusion line on the CB2 side. The joints exhibit good mechanical properties in spite of the presence of a thin layer with very high hardness in the heat affected zone (HAZ) on the CB2 steel side. [1].
The scope of this study was to ascertain the weldability of cast nickel base alloy 625 with cast martensitic 9% chromium steel COST CB2, using electron beam welding (EBW). Similar (A625/A625) and dissimilar joint welding experiments on 50 mm thick plates were executed. Microstructure of welded joints was investigated and mechanical-technological tests were carried out.
Results show that work pieces were completely welded and the microstructure of the seam shows no problems except some δ-ferrite grains near the fusion line on the CB2 side. The joints exhibit good mechanical properties in spite of the presence of a thin layer with very high hardness in the heat affected zone (HAZ) on the CB2 steel side. [1].
| Original language | English |
|---|---|
| Pages (from-to) | 184-194 |
| Journal | Procedia Engineering |
| Volume | 86 |
| DOIs | |
| Publication status | Published - 2014 |
Fields of Expertise
- Advanced Materials Science
Treatment code (Nähere Zuordnung)
- Application
- Experimental