Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems

Research output: Contribution to conferencePaperResearchpeer-review

Abstract

This publication demonstrates that flywheel energy storage systems (FESS) are a valid alternative to batteries for storing energy generated by decentralized rooftop photovoltaic systems. The increasing number of private PV arrays calls out for high energy storage capacities in order not to overload the grid. Despite being the current storage technology of choice, chemical batteries are still too expensive and have certain disadvantages compared to FESS, such as capacity fade over time and currently still difficult recycling. Within a research project at the Graz University of Technology a feasibility study for a low-cost, low-loss FESS was conducted. Energetic dimensioning was performed using actual PV power and electric load data recorded at a building in Austria with 6 apartment units. A low-cost flywheel system with an energy content of 5.0 kWh and 2.2 kW maximum rated power using a steel rotor and economic off-the shelf components was designed and investigated. Self-discharge of the proposed FESS design was significantly reduced using a cast silicone bearing seat, which allows supercritical rotor operation. Axial bearing loads were compensated by nearly 100% via repelling permanent magnets allowing drastic down-sizing of the bearings and further reduction of torque loss. The concept was validated by a small-scale test setup, which showed promising results. Finally, an improved design option is compared to the initially proposed FESS in terms of costs and self-discharge.
Original languageEnglish
Number of pages10
Publication statusPublished - Aug 2016
Event4th IEEE International Conference on Sustainable Energy Engineering and Application - Jakarta, Indonesia
Duration: 3 Oct 20165 Oct 2016

Conference

Conference4th IEEE International Conference on Sustainable Energy Engineering and Application
Abbreviated titleICSEEA
CountryIndonesia
CityJakarta
Period3/10/165/10/16

Cite this

Buchroithner, A., Haan, A., Preßmair, R., Schweighofer, B., Wegleiter, H., & Edtmayer, H. (2016). Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems. Paper presented at 4th IEEE International Conference on Sustainable Energy Engineering and Application, Jakarta, Indonesia.

Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems. / Buchroithner, Armin; Haan, Alexander; Preßmair, Rupert; Schweighofer, Bernhard; Wegleiter, Hannes; Edtmayer, Hermann.

2016. Paper presented at 4th IEEE International Conference on Sustainable Energy Engineering and Application, Jakarta, Indonesia.

Research output: Contribution to conferencePaperResearchpeer-review

Buchroithner, A, Haan, A, Preßmair, R, Schweighofer, B, Wegleiter, H & Edtmayer, H 2016, 'Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems' Paper presented at 4th IEEE International Conference on Sustainable Energy Engineering and Application, Jakarta, Indonesia, 3/10/16 - 5/10/16, .
Buchroithner A, Haan A, Preßmair R, Schweighofer B, Wegleiter H, Edtmayer H. Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems. 2016. Paper presented at 4th IEEE International Conference on Sustainable Energy Engineering and Application, Jakarta, Indonesia.
Buchroithner, Armin ; Haan, Alexander ; Preßmair, Rupert ; Schweighofer, Bernhard ; Wegleiter, Hannes ; Edtmayer, Hermann. / Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems. Paper presented at 4th IEEE International Conference on Sustainable Energy Engineering and Application, Jakarta, Indonesia.10 p.
@conference{fc5add18405e4dce8afe5ed1d235c726,
title = "Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems",
abstract = "This publication demonstrates that flywheel energy storage systems (FESS) are a valid alternative to batteries for storing energy generated by decentralized rooftop photovoltaic systems. The increasing number of private PV arrays calls out for high energy storage capacities in order not to overload the grid. Despite being the current storage technology of choice, chemical batteries are still too expensive and have certain disadvantages compared to FESS, such as capacity fade over time and currently still difficult recycling. Within a research project at the Graz University of Technology a feasibility study for a low-cost, low-loss FESS was conducted. Energetic dimensioning was performed using actual PV power and electric load data recorded at a building in Austria with 6 apartment units. A low-cost flywheel system with an energy content of 5.0 kWh and 2.2 kW maximum rated power using a steel rotor and economic off-the shelf components was designed and investigated. Self-discharge of the proposed FESS design was significantly reduced using a cast silicone bearing seat, which allows supercritical rotor operation. Axial bearing loads were compensated by nearly 100{\%} via repelling permanent magnets allowing drastic down-sizing of the bearings and further reduction of torque loss. The concept was validated by a small-scale test setup, which showed promising results. Finally, an improved design option is compared to the initially proposed FESS in terms of costs and self-discharge.",
author = "Armin Buchroithner and Alexander Haan and Rupert Pre{\ss}mair and Bernhard Schweighofer and Hannes Wegleiter and Hermann Edtmayer",
year = "2016",
month = "8",
language = "English",
note = "4th IEEE International Conference on Sustainable Energy Engineering and Application, ICSEEA ; Conference date: 03-10-2016 Through 05-10-2016",

}

TY - CONF

T1 - Decentralized Low-Cost Flywheel Energy Storage for Photovoltaic Systems

AU - Buchroithner, Armin

AU - Haan, Alexander

AU - Preßmair, Rupert

AU - Schweighofer, Bernhard

AU - Wegleiter, Hannes

AU - Edtmayer, Hermann

PY - 2016/8

Y1 - 2016/8

N2 - This publication demonstrates that flywheel energy storage systems (FESS) are a valid alternative to batteries for storing energy generated by decentralized rooftop photovoltaic systems. The increasing number of private PV arrays calls out for high energy storage capacities in order not to overload the grid. Despite being the current storage technology of choice, chemical batteries are still too expensive and have certain disadvantages compared to FESS, such as capacity fade over time and currently still difficult recycling. Within a research project at the Graz University of Technology a feasibility study for a low-cost, low-loss FESS was conducted. Energetic dimensioning was performed using actual PV power and electric load data recorded at a building in Austria with 6 apartment units. A low-cost flywheel system with an energy content of 5.0 kWh and 2.2 kW maximum rated power using a steel rotor and economic off-the shelf components was designed and investigated. Self-discharge of the proposed FESS design was significantly reduced using a cast silicone bearing seat, which allows supercritical rotor operation. Axial bearing loads were compensated by nearly 100% via repelling permanent magnets allowing drastic down-sizing of the bearings and further reduction of torque loss. The concept was validated by a small-scale test setup, which showed promising results. Finally, an improved design option is compared to the initially proposed FESS in terms of costs and self-discharge.

AB - This publication demonstrates that flywheel energy storage systems (FESS) are a valid alternative to batteries for storing energy generated by decentralized rooftop photovoltaic systems. The increasing number of private PV arrays calls out for high energy storage capacities in order not to overload the grid. Despite being the current storage technology of choice, chemical batteries are still too expensive and have certain disadvantages compared to FESS, such as capacity fade over time and currently still difficult recycling. Within a research project at the Graz University of Technology a feasibility study for a low-cost, low-loss FESS was conducted. Energetic dimensioning was performed using actual PV power and electric load data recorded at a building in Austria with 6 apartment units. A low-cost flywheel system with an energy content of 5.0 kWh and 2.2 kW maximum rated power using a steel rotor and economic off-the shelf components was designed and investigated. Self-discharge of the proposed FESS design was significantly reduced using a cast silicone bearing seat, which allows supercritical rotor operation. Axial bearing loads were compensated by nearly 100% via repelling permanent magnets allowing drastic down-sizing of the bearings and further reduction of torque loss. The concept was validated by a small-scale test setup, which showed promising results. Finally, an improved design option is compared to the initially proposed FESS in terms of costs and self-discharge.

M3 - Paper

ER -