Corrosion behavior of metal–composite hybrid joints: Influence of precipitation state and bonding zones

Natalia M. André*, Anissa Boualib, Emad Maawad, P. Staron, Jorge F.dos Santos, Mikhail L. Zheludkevich, Sergio T. Amancio-Filho

*Corresponding author for this work

Research output: Contribution to journalArticlepeer-review


The corrosion behavior of AA2024-T3/carbon-fiber-reinforced polyphenylene sulfide joints was investigated. The joints were exposed to salt spray from one to six weeks. The residual strength of these joints was assessed using lap shear test. The corroded surfaces and interfaces were analyzed using small angle X-ray scattering, scanning electron microscopy, and energy dispersive spectroscopy. Regarding the top surface of the joints, the aluminum part corroded preferably in the heat-affected zone (HAZ). It was demonstrated that the HAZ is more susceptible to corrosion than the stir zone (SZ) due to the anodic sites formed by coarse intermetallic particles and S’(S) phase precipitation. Besides, the macro-galvanic coupling between the zones may also potentialize the corrosion in HAZ as the base material and SZ displayed a lower volume fraction of S’(S) than HAZ. In addition, the corrosion at the interface of the joints was evaluated. Four different stages in the development of corrosion at the interface were identified. At Stage I, the joints showed fast strength degradation (0% to -24% of ultimate lap shear force (ULSF) due to water absorption and NaCl migration into the composite. At Stage II, the strength degradation of the joints was stalled (-24% to -28% of ULSF) due to the protection provided to the bonding area by the reconsolidated layer of polymer at the borders of the joint. The polymeric layer acted as a protective coating on the aluminum surface. At Stage III, the corrosion overcame the polymeric layer by reaching the bonding area of the joint. As a result, the strength of the joints rapidly degraded from -28% to -44% of ULSF. Finally, at Stage IV, one expects generalized corrosion in the bonding area, leading to the final strength degradation of the joint.

Original languageEnglish
Article number108075
JournalCorrosion Science
Publication statusPublished - 1 Sep 2019


  • Aluminium
  • Carbon fiber reinforced polymer (CFRP)
  • Galvanic corrosion
  • Intergranular corrosion
  • Residual strength
  • Small angle X-ray scattering (SAXS)

ASJC Scopus subject areas

  • Chemistry(all)
  • Chemical Engineering(all)
  • Materials Science(all)


Dive into the research topics of 'Corrosion behavior of metal–composite hybrid joints: Influence of precipitation state and bonding zones'. Together they form a unique fingerprint.

Cite this