Materials for Ultra Efficient Low Emission Power Plants

  • Holzer, Ivan, (Co-Investigator (CoI))
  • Sonderegger, Bernhard (Co-Investigator (CoI))
  • Pein, Cornelia, (Co-Investigator (CoI))
  • Kozeschnik, Ernst (Co-Investigator (CoI))
  • Cerjak, Horst-Hannes (Principal Investigator (PI))
  • Mayr, Peter, (Co-Investigator (CoI))
  • Mendez Martin, Francisca, (Co-Investigator (CoI))

Project: Research area

Description

Through the higher operating temperatures for steam power plants it will be possible to raise the service temperature and thus raise the efficiency and lower the emissions. In the last decades the ferritic-martensitic 9-12% chromium steels were further developed only by experimental methods which gave no insight and physical understanding of the important parameters which strongly affect the creep behaviour. The objective of this project is, as an essential part of the European research initiative COST 536, to get a reliable description of the high-temperature behaviour and stability for the modern 9-12%Cr steels.
StatusFinished
Effective start/end date1/11/99 → 28/02/09
View all
View less

Related content

Research Outputs

Werkstoffmodellierung mit MatCalc und Anwendung für die Entwicklung eines neuen Stahls mit verbesserten kriech- und Schweißeigenschaften

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

Microstructural Creep Mechanisms in 9-12% Cr Steels

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

Simulation Of Precipitation In A Complex 9-12% Cr Steel

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

A general approch to microstructural modelling of creep

Research output: Contribution to conference › Poster › Research

Precipitation in 9-12% Cr steels

Research output: Book/Report › Other report › Research

A Comprehensive Approach on the Development and Improvement of 9-12% Cr Steels

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

Microstructure Evolution of 12% Cr Steel

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research

EFTEM, EELS and EDX Investigations on a Creep Resistant 9-12% Cr Steel

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

In situ Observation of Phase Transformation and their Effects in 9-12% Cr Steels During Welding

Research output: Contribution to journal › Article › Research › peer-review

Modelling precipitation kinetics in a complex 9-12% Cr steel

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

Charakterisierung und Überprüfung der Schweißeignung des neu entwickelten hochwarmfesten Werkstoffs P23

Research output: Thesis › Diploma Thesis › Research

A Comprehensive Approach to Predicting Microstructural Stability in Creep Resistant Steels

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

Kriechen und Schädigungsentwicklung bei hochwarmfesten Werkstoffen

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

Microstructural analysis on a creep resistant martensitic 9-12% Cr steel using the EBSD method

Research output: Contribution to journal › Article › Research › peer-review

A general approach to microstructural modelling of creep

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

Werkstoffmodellierung mit MatCalc und Anwendung für die Entwicklung eines neuen Stahls mit verbesserten kriech- und Schweißeigenschaften

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

A Comprehensive Approach on the Development and Improvement of 9-12% Cr Steels

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

Martensite laths in creep resistant martensitic 9-12% Cr steels - Calculation and measurement of misorientations

Research output: Contribution to journal › Article › Research › peer-review

Aspects of welding of advanced 9-12% Cr steels for thermal power plants and HSLA steels for power plants application

Research output: Chapter in Book/Report/Conference proceeding › Conference contribution › Research › peer-review

Simulation Of Precipitation In A Complex 9-12% Cr Steel

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

Gleichgewichtsbetrachtungen an Stählen der Reihe FB2-X

Research output: Book/Report › Commissioned report › Research

Development and Improvement of 9-12% CR Steels by a Holistic R & D Concept

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

EFTEM, EELS and EDX Investigations on a Creep Resistant 9-12% Cr Steel

Research output: Contribution to conference › (Old data) Lecture or Presentation › Research

Projects

CTFM - Creep Testing of Forged Grade 91 and Grade 92 Base Material - CTFM

Project: Research project

CTVAM - Crossweld Creep Testing of Grade 92 for thermal power plant applications

Project: Research project

KW50plus (enhance power stations efficiency to more than 50 percent)

Project: Research project

Charakterisierung d Substruktur - Characterisation of the Substructure of Modern Power Plant Materials Using the EBSD Method

Project: Research project

Computer simulation of precipitation kinetics in solid metals and application to the complex power plant steel CB8

Project: Research project

Modelling and Simulation of interactions between microstructure and creep behaviour in modern ferritic/martensitic 9-12% Cr-steels

Project: Research project

Weldability of modern 9-12%Cr steels for low emission thermal power generation

Project: Research project

FFF - ACCEPT COST 536 - Alloy development for critical components of environmentally friendly power plants

Project: Research project

EU - CRESTA - New Creep Resistant Stable Steel for USC Power

Project: Research project

OPTIBORN - Fine Tuning of Boron and Nitrogen in ASTM grade 92

Project: Research project