Energieschwamm - The building as an energy sponge - stream purely - warmth out

Project: Research project

Description

The use of the building mass, especially the floors and suspended ceilings, as thermal energy storage is increasing in importance, driven by the trend to decentralized heating
systems on the basis of solar energy (solar thermal, photovoltaic, wind energy), which delivers energy independently of the demand and therefore requires some form of storage. In
addition, the market shows significantly more volatile electricity prices, which also increases the demand for energy storage. While any type of additionally installed storage (water storage, battery) partly causes considerable costs and space requirements, the building mass is available free of charge, and has “only” to be activated. Simulation studies that have
already been carried out as well as realized buildings show a very large storage potential by activating the building mass. The storage of electrical energy in the form of heat can be done
most efficiently via a heat pump, since the heat to be stored can be increased by a factor of 3 to 4 compared to the input electrical energy by means of environmental heat.
The problem is to store the right amount of energy with the right power at the right time and at the right place, considering the question of residential comfort (too high / low temperatures
due to overheating / undercooling) and the potentially increased heat loss of the building. At the same time, the heat pump heating system must be as efficient as possible, so that the heat is generated at as low temperatures as possible. This is true not only for the heating demand but with buildings requiring less and less heating especially for domestic hot water
preparation.
The goal of the project is the development and demonstration of innovative, dynamic control concepts in combination with (ambient air) heat pumps, which enable the best possible heat
storage of electricity (PV self-consumption or excess electricity from the grid) in the building mass of multi-family buildings with the best possible but also variable comfort parameters by
means of individual room control with overheating/undercooling of room temperatures.
Furthermore, the domestic hot water system will also be designed to be significantly more efficient at lower temperatures thanks to innovative (hygiene) measures, and to have a
significantly increased storage potential for PV or excess electricity from the grid. The domestic hot water preparation in summer by using excess electricity for space cooling by
means of a reversible heat pump is intended to further increase the overall efficiency as well as the decentralized electricity storage potential. But also the decisive factors and motivators
for a good user acceptance are to be determined as a basis for the development of potentially successful business models.
As a result, in practice tests at least approximately confirmed control concepts are expected, which lead to a significant electricity storage potential in the form of heat storage through
building mass activation with a high overall system efficiency. Insights into user acceptance from practice tests in real buildings will provide an important basis for the implementation and final development of business models.
StatusActive
Effective start/end date1/10/1730/09/20